Draytek Vigor2620 Series, User Manual, Page: 550 / 610

Vigor2620 Series User’s Guide 538
<enable>: Enter 1 or 0.
-v <enable> Enable (1) or disable (0) VPN Log.
<enable>: Enter 1 or 0.
-e <enable> Enable (1) or disable (0) User Access Log.
<enable>: Enter 1 or 0.
-c <enable> Enable (1) or disable (0) Call Log.
<enable>: Enter 1 or 0.
-w <enable> Enable (1) or disable (0) WAN Log.
<enable>: Enter 1 or 0.
-r <enable> Enable (1) or disable (0) Router/DSL Information.
<enable>: Enter 1 or 0.
-t <enable> Enable (1) or disable (0) AlertLog Setup.
<enable>: Enter 1 or 0.
-o <port> Define the port number for AlertLog.
<port>: Enter a port value (1~65535).
-p Update the IP address of the server.
-W <mode> Define the action (1 for overwritting the oldest logs or 0 for
stopping the logs) of syslog.
<mode>: Enter 1 or 0.
-U <unit> Set the unit (1 for MB or 0 for GB) of Syslog storing on a USB
disk.
<unit>: Enter 1 or 0.
-S <capacity> Define the folder capacity of a USB disk.
<capacity>: Enter 1~16GB or 1~1024MB.
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> sys syslog -a 1 -s 1 -i 192.168.1.25 -d 514
> sys syslog –p
> Updating server IP address..
T
T
e
e
l
l
n
n
e
e
t
t
C
C
o
o
m
m
m
m
a
a
n
n
d
d
:
:
s
s
y
y
s
s
m
m
a
a
i
i
l
l
a
a
l
l
e
e
r
r
t
t
This command is used to configure settings for mail alert function.
S S y y n n t t a a x x
sys mailalert <command><parameter>/…
S
S
y
y
n
n
t
t
a
a
x
x
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n
Parameter Description
<command><parameter>/
…
The available commands with parameters are listed below.
[…] means that you can Enter several commands in one line.
-e <0/1> Enable (1) or disable (0) the mail alert function.
<0/1>: Enter 0 or 1.
-i <SMTP Server IP> Set the SMTP sever IP address.
<SMTP Server IP>: Enter an IP address.
-o <SMTP Server Port> Set the port number for SMTP server.
<SMTP Server Port>: Enter a number (1~65535).
-a <Mail Address> Set Alert Mail Reciver E-maiil Address.
<Mail Address>: Enter a mail address.
-r <Mail Address> Set Mail Return E-mail Address.
<Mail Address>: Enter a mail address.
-s <0/1> Enable/Disable Use SSL.
<0/1>: Enter 0 or 1.
-h <0/1> Enable/Disable SMTP Authentication.
<0/1>: Enter 0 or 1.
-u <Username> Set Username for SMTP Authentication.
<Username>: Enter a string as username.