Instructions for use
Polaris 600
77
Maintenance
Adjusting the arm system
Adjusting the spring arm
The spring arm must hold the mounted light in any
height position.
Adjusting the height stop
Vertical movement of the light is limited by a fixed
lower and adjustable upper stop. The adjustable
upper stop (height stop) can be set to any position
between the positions (A) and (B). The factory
setting for the spring arm is position (B).
1
Press down the seal inside the joint.
2
Adjust the height stop for the spring arm using
the set screw (C).
Use an Allen key (size 5 mm) for this.
Turn the set screw counterclockwise to adjust
the stop upwards.
Pay attention to the distance to the ceiling.
Turn the set screw clockwise to adjust the stop
downwards.
Adjusting the spring force
The spring force of the spring arm must be
adjusted if the light does not remain at the set
height.
When adjusting the spring arm, lift it approx. 10
o
above the horizontal position. Only in this position
is it possible to turn the set screw.
If necessary, set the upper stop (height stop) to a
higher position.
1
Raise the spring arm approx. 10
o
above the
horizontal position.
2
Press down the seal inside the joint.
3
Adjust the spring force for the spring arm using
the set screw (A).
Use an Allen key (size 5 mm) for this.
Turn the set screw clockwise to increase the
spring force.
Turn the set screw counterclockwise to
decrease the spring force.
27202
C
A
B
27203
10
O
A