DR 30.00 COMMERCIAL RAPID-FEED CHIPPER, Safety & Operating Instructions Manual

Page: 59 / 80

CONTACT US AT
www.DRpower.com
or CALL TOLL FREE
1-800-DR-OWNER
55
ar from the axle by loosening the Set
Screw with a 5/32" allen wrench and pulling the Collar
the Axle from the
6. Slide the Spacer, Wheel and Collar back onto the Axle
7. Remove the four Bolts, Lock Washers and Nuts (two
l e ly) from the side of
the chipper Frame with two 9 16" wrenches ( Figure
5
8. P ti
Washers and Nuts (Two large washers on top two
holes o
) e ( Figure
56 ).
9. Repeat e
r
ith two Bolts,
and
3. Remove the Coll
off.
4. Remove the Wheel and Spacer that is behind the
Collar from the Axle.
Figu
Fender
Bolt, Nut, Lock
Washer and Flat
Washer (top two
holes)
Bolt, Nut and
Lock Washer
(bottom two
holes)
Bolt, Nut, Lock
Washer and Flat
Washer (top two
holes)
Bolt, Nut and
Lock Washer
(bottom two
holes)
Figure 55
re 56
5. Pull the opposite wheel along with
Chipper.
and store in a safe place.
arg washers on top two hole
/
s on
5
).
osi on the Fender and reinstall the four Bolts, Lock
nly to the side of the chipper Fram
th Fender installation for the opposite side.
10. Position the new Axle Assembly under the Chippe
and secure it to the Axle Brackets w
Figure 57
Axle
Assembly
Mounting
Slots this
side
Axle Bracket
Axle
Assembly
Hardware
Locknuts and Washers (on the side with slots)
two Bolts and Locknuts (on side with holes) using two
9/16" wrenches (
Figure 57 ).