DR 30.00 COMMERCIAL RAPID-FEED CHIPPER, Safety & Operating Instructions Manual

Page: 45 / 80

CONTACT US AT
www.DRpower.com
or CALL TOLL FREE
1-800-DR-OWNER
41
Removing and Replacing the Wheels
pressed in
s
Wheel is off the ground.
ocking Collar ( Figure 43 ).
NOTE: There is a spacer behind the wheel that must remain
on the Axle when the Pneumatic Whe ced.
NOTE: File off the Set Screw marks in the Axle if Wheel will
not slide on.
4. Install the Pneumatic Wheel onto the Axle and against
the Spacer with the Valve side facing out.
5. Install the Locking Collar onto the Axle against the
Wheel and tighten the Set Screw with a 5/32" Allen
Wrench.
6. Check the Pneumatic Wheels for proper air pressure
of 38 psi. maximum in each tire (see Chapter 3).
Removing and Replacing the Clutch
The design of the Clutch on your machine is for rugged, dependable service, however, it is important to
understand the limitations of a Clutch. The Clutch design is to provide load free starting of the Engine,
and slippage under excessive overloading of the driven application. These features help protect the
Engine from damages such as broken crankshafts and starters. The Shoes and Springs on the Clutch
are normal wear ite
u notice decreased performance of the Clutch, check and replace it if
necessary.
INE, WAIT FOR ALL MOVING PARTS TO COME TO A COMPLETE STOP,
REMOVE SP NEGATIVE BATTERY CABLE, THEN WAIT 5 MINUTES
BEFO P SPECTI
The Wheels on the DR 30.00 FTP COMMERCIAL Rapid Feed Chipper are pneumatic and have
Bearings for easy transport. With use, tires or Bearings may need replacing. The following procedure
will explain the replacement procedures.
SHUT DOWN THE ENG
ARK PLUG WIRES, DISCONNECT THE
RE ERFORMING ANY MAINTENANCE PROCEDURE OR IN ON ON THE CHIPPER.
Tools Needed:
•
5/32" allen wrench
•
Fine Tooth File
•
Jack
Jack up the side of the Chipper just until the
Pneumatic
Pneumatic
Wheel
Figure 43
Locking
Collar
Set Screw
Axle
1.
2. Loosen the Set Screw with a 5/32" allen wrench and
remove the L
3. Remove the Pneumatic Wheel from the Axle.
el is repla
ms. If yo