DR 30.00 COMMERCIAL RAPID-FEED CHIPPER, Safety & Operating Instructions Manual

Page: 25 / 80

CHAPTER 4
OPERATING YOUR 30.00 COMMERCIAL DR RAPID-FEED
CHIPPER
This chapter covers the procedures for starting and stopping your new 30.00 COMMERCIAL DR RAPID-
e Starting the Engine
FEED CHIPPER and discusses basic operation features.
ry time
•
THE DESIGN OF THIS MACHINE IS FOR CHIPPING WOOD. NEVER USE THIS MACHINE FOR ANY
OTHER PURPOSE AS IT COULD CAUSE SERIOUS INJURY.
•
CONTACT WITH INTERNAL ROTATING PARTS WILL CAUSE SERIOUS PERSONAL INJURY. NEVER PUT
HANDS, FACE, FEET, OR CLOTHING INTO CHIPPER HOPPER OR DISCHARGE OPENING OR NEAR
THE DISCHARGE AREA AT ANY TIME.
•
BEFORE PERFORMING ANY MAINTENANCE PROCEDURE OR INSPECTION, SHUT DOWN THE
ENGINE, WAIT FOR ALL MOVING PARTS TO COME TO A COMPLETE STOP (THE FLYWHEEL WILL
CONTINUE ROTATING FOR A WHILE AFTER THE ENGINE IS SHUT DOWN), DISCONNECT SPARK
PLUG WIRES, KEEPING THEM AWAY FROM THE SPARK PLUGS TO PREVENT ACCIDENTAL STARTING,
DISCONNECT THE NEGATIVE BATTERY CABLE, THEN WAIT 5 MINUTES BEFORE PROCEEDING. USE
ONLY A WOODEN STICK TO CLEAR JAMMED MATERIAL.
Befor
1. Check the oil level eve you use the 30.00
oil if
2. vel. Add fuel as needed (see Chapter 3
3. N”
4. ildup from the machine before
“ON”
“OFF”
Fuel
Shut-Off
Valve
COMMERCIAL DR RAPID-FEED CHIPPER. Add
needed (see Chapter 3 section “Adding Engine Oil and
Gasoline”.
Check the fuel le
section “Adding Engine Oil and Gasoline”.
Ensure that the Fuel Shut-Off Valve is in the “O
position (
Figure 14 ).
Remove any debris bu
Figure 14
every use of the Chipper.
TE: Check and re-tighten th NO e Drive Belt, if necessary, after
pter an initial break-in period of one (1) hour (see Cha
5 “Maintaining the 30.00 Commercial DR Rapid-
Feed Chipper”).
CONTACT US AT
www.DRpower.com
or CALL TOLL FREE
1-800-DR-OWNER
21