DR 30.00 COMMERCIAL RAPID-FEED CHIPPER, Safety & Operating Instructions Manual

Page: 63 / 80

CONTACT US AT
www.DRpower.com
or CALL TOLL FREE
1-800-DR-OWNER
59
Towi
the Tow Hitch Assembly up
2. ow Hitch Assembly
vehicle ensuring there
is enough slack for turning.
h
.
If there are any questions, contact us at
www.DRpower.com or call 1-800-DR-OWNER (376-9637) .
ng
NOTE: The Tow Bar must be in the horizontal (towing)
position for the following procedures.
1. Pull the latch assembly on
and into the open position. Position the hitch coupler
of the Chipper over and onto the tow vehicle’s tow ball
(must be a 2" tow ball) (
Figure 67 ).
Close the Latch Assembly on the T
to lock it onto the Tow Ball (Figure 68) . Attach the
towing Safety Chains to the tow
3. Slide the Locking Pin into the hole in the Latc
Assembly.
4. For extra safety and security, you may want to
purchase a Lock or Lock Pin to install into the Latch
(Figure 69) Assembly of the Tow-Hitch Package
5. Connect the Wire Harness Connector to your Tow
Vehicle and ensure that your lights on the Chipper are
working properly.
Figure 68
A
Tow
Hitch
ssembly
Latch
Assembly
Safety
Chains
MAKING SURE THE CHIPPER IS SECURELY ATTACHED TO
THE VEHICLE IS THE RESPONSIBILITY OF THE
OWNER/OPERATOR. FAILURE TO SECURELY ATTACH THE
CHIPPER CAN CAUSE LOSS OF CONTROL OF THE VEHICLE
OR THE CHIPPER BEING SEPARATED FROM THE TOWING
VEHICLE, RESULTING IN SERIOUS INJURY OR DEATH.
Figure 69
Latch
Assembly
Lock or
Lock Pin
Figure 67
Tow
Hitch
Assembly
2" Tow Ball
Latch
Assembly