DR 30.00 COMMERCIAL RAPID-FEED CHIPPER, Safety & Operating Instructions Manual

Page: 34 / 80

30 30.00 COMMERCIAL
DR
®
RAPID-FEED™ CHIPPER
s
icate
ings of the Chipper Assembly.
Tools and Supplies needed:
•
Clean cloth
•
5/32" Allen Wrench
•
Loctite
®
243 (if needed)
and
e Belt” in this Chapter).
2. Wipe all dirt, etc., from the grease fittings with a clean
cloth (
F
3. Apply no more than three pumps of quality general-
purpose lithium grease with a hand-pumped grease
gun to each Bearing Grease Fitting, one on either side
of the Chipper Assembly.
4. Check the Set Screws for tightness. If they are not tight
they should be removed, apply Loctite
® to the threads,
then rein the Set Screws.
5. Replace the Belt Guard.
Grease Fitting
Your DR RAPID-FEED CHIPPER was greased at the Factory. The operator needs to periodically lubr
the two Bear
SHUT DOWN THE ENGINE, WAIT FOR ALL MOVING PARTS TO COME TO A COMPLETE STOP, REMOVE
SPARK PLUG WIRES, DISCONNECT THE NEGATIVE BATTERY CABLE, THEN WAIT 5 MINUTES B
•
Flexible hose grease gun
•
Lithium grease
1. Remove the Belt Cover (see “Removing, Replacing
Adjusting the Driv
igure 21 ).
stall and tighten
EFORE
PERFORMING ANY MAINTENANCE PROCEDURE OR INSPECTION ON THE CHIPPER.
Set
Screw
Bearing
Front Chipper Bearing
Grease
Fitting
Rear Chipper Bearing (under Belt Cover)
Figure 21
Grease
Fitting
Bearing
Set
Screw
OVER LUBRICATION DAMAGE TH BEARINGS. CAN E