Trigenflex R96
Ceiling, Wall, Standmodel
Dr. Mach
Lamps and Engineering
59230001
Edition 01
18.02.2002 / Bak Page 15/23
8
7
6
4
3
2
5
4
1
5
4.4.3 Changing the filter disk
The dielectric filter disk between reflector and splin-
ter protection disk prevents a damaging heating of
the illuminated area.
The lamp may not be used without this filter
To change the filter disk proceed as follows:
•
Turn off the lamp.
•
Rotate the three quick-release fasteners
1
half a
turn anticlockwise so that the corresponding disk
bearer can be removed from the bottom part of
the lamp housing.
•
Slightly loosen nuts
2
, carefully bend the retain-
ing springs
4
apart and replace the filter disk
5
.
Only use filter disks which have been cleaned
accordingly.
4.4.4 Changing the splinter protection
disk
In case the light quality is getting worse because of
a dull splinter protection disk, it may be necessary
to change the disk.
To change the splinter protection disk proceed as
follows:
•
Turn off the lamp.
•
Rotate the three quick-release fasteners
1
half a
turn anticlockwise so that the corresponding disk
bearer can be removed from the bottom part of
the lamp housing.
•
Remove filter disk
5
as described under 4.4.3.
•
Loosen the three M3 nuts
2
, remove retaining
spring
4
and retaining ring
6
.
•
Replace splinter protection disk
7
and lay stay
tube
8
, retaining ring, retaining spring and clamp
in the correct order on the disk bearer according
to the illustration.
•
Place nuts
2
onto the threaded bolts according
to the illustration and tighten.
•
Carefully bend the retaining springs
4
apart and
replace filter disk.
Only use filter disks which have been cleaned
accordingly.
•
Replace disk bearer and fasten by turning the
three quick-release fasteners
1
.
