Trigenflex R96
Ceiling, Wall, Standmodel
Dr. Mach
Lamps and Engineering
59230001
Edition 01
18.02.2002 / Bak Page 6/23
If you measure a voltage in excess of 40V DC, switch off the lamp.
Return the first jumper to the initial position.
Take off the second jumper and place it back on one of the two pins.
Switch on the lamp again. Finally repeat the voltage measurement. The voltage is now adjusted.
Close the lamp by replacing the cover.
2.2 ON/OFF switch,
light intensity adjustment
♦
Design for power supply 24V (Figure A)
Ceiling/ wall model
There are no ON/OFF switches on the lamp.
The customer must provide a two-pole ON/OFF switch
(see also point 5 of the mounting instructions).
Remark:
In case of Trigenflex R96 lights for power
supply 24V there is no switch for two-step light inten-
sity adjustment.
♦
Toroid transformer design for
power supply 230V/120V AC (Figure B)
Ceiling/ wall model
The rocker switch
1
switches the lamp ON and OFF.
The rocker switch
2
adjusts the light intensity from
bright to dark.
A
B
2
1
♦
Stand model (Figure C)
The ON/OFF switch is in the counter
balance
3
.
There are no ON/OFF switches on the
lamp.
C
3
ON/OFF
