41
Remote Operation
6.6.6 ROUTE:COUNTx n?
x = switch address.
n = position of the switch.
Syntax
ROUTe:COUNTx n?
:COUNTx n?
Description
This command counts how many times switch ‘x’ has cycled to position ‘n’,
where ‘x’ is the address of the switch and ‘n’ is the position of the switch.
This will give the user how many times only a single position has been
cycled.
Result
n
Possible error codes
4
6.6.7 ROUTE:RESCOUNTx v
x = switch address.
v = value to reset the count to.
Syntax
ROUTe:RESCOUNTx v
:RESCOUNTx v
Description
This command resets the count of the cycles for switch ‘x’ to a value
determined by the user ‘v’. Here ‘x’ is the address of the switch the user
wishes to reset, and ‘v’ is the value the user wants to set the count to. The
valu
e ‘v’ should be 0 since this command is typically only used if the user
replaces a switch.
WARNING: This should only be used when replacing a switch and
resetting the count to 0.
Result
This will set the cycle count of switch ‘x’ to a value ‘v’ determined by the
user. The value ‘v’ should set to 0 if the user is replacing the switch.
Possible error codes
4