23
SCIP Command Operation
6.4.3 *RST
Syntax
*RST
Description
This command performs a device reset.
This will set the instrument so that all switches are in the default state.
For SPnT switches the default state is: all RF ports are open (position 0).
For the latching SPDT the default position is 1.
For a transfer switch the default state is: position 1 is closed.
Possible error codes
11, 12, 13
Timing
Before issuing any other command after a
*RST
use the following
considerations.
The
*RST
command is ‘translated’ by the internal controller board to
command, on the GPIO bus level, each switch to position 0 (open) or 1
depending on the type of switch. The amount of these commands depends
on the amount of switches present in the matrix.
Each switch requires approximately 10-15ms to switch position. So to
execute an
*RST
command (to open all positions without verifying the
switch’s positions) will require at least n x (10 - 15ms), where n is the
number of switches in the matrix.
6.4.4 SET:DHCP ON/OFF
Syntax
SET:DHCP ON
SET:DHCP OFF
Description
This command turns on and off the Dynamic Host Configuration Protocol
(DHCP). This is used if a static IP address is wanted or let the DHCP
choose an IP address automatically. The default static IP address is
10.180.50.233.
Factory default value
OFF
Possible error codes
4