24
en
Operation
LED lights are extremely energy efficient and, under normal operation, have a very long life. To
ensure the maximum life of the LED and to increase the energy efficiency, the following should be
considered:
■ The turning on and off of the luminary should be carried out by the input circuit of the power
supply.
■ The turning off of the luminary via the PWM signal should not occur permanently since in this
case the electronics unit of the luminary continues operating.
■ Even if the luminary is equipped with a THERMOPROTECT system that protects the luminary
against thermal damage, a permanent abnormal operation should be avoided.
■ The heat dissipation of the LED must not be hindered. Therefore, do not cover the spot.
■ Avoid operating the spot in case of direct solar radiation.
■ In automatic mode, control the spot via timer and / or twilight switch.
Maintenance, disposal
Care
■ Clean the spot with a damp cloth every now and then.
■ The luminaries are made of stainless V4A steel. However, depending on the environmental
conditions and the surfacing material, the metal parts may present the so-called flash rust, but
this does not constitute a defect. Flash rust can be removed easily with appropriate stainless
steel cleaners. Flash rust is particularly likely when the housing comes into contact with ferrous
particles (e.g. iron and grinding dust, ferrous plant fertilizers or the like).
Illuminants
LED lights, under normal operation, have a very long life. Therefore, the replacement of the lamp is
not provided. In case of questions, see the Service chapter.
Disposal
At the end of the useful life, dispose of the spot and all accessories in accordance with the appli-
cable environmental regulations. Electrical waste must not be disposed of with domestic waste.
Summary of Contents for brilliance-midi
Page 13: ...13 de Notizen...
Page 27: ...27 en Notes...
