Safety
Safety instructions
High ambient temperatures shorten the life of the LED’s. Ensure a good heat dissipation in order to
guarantee a long life of the LED. During operation, do not expose the spot to ambient temperatures
of > 50°C. Do not cover the spot, provide free air circulation.
Do not open the housing of the luminary.
Assembly
Preparation
Depending on the configuration, unpack all the parts included in the scope of delivery and check
them for completeness and intactness.
Dispose of the packaging material no longer needed in accordance with applicable regulations.
If you notice any damage from transport, immediately contact the dealer where you purchased the
luminary.
Mechanical installation
For the versions with connector system M12 and a floor mounting with the risk of flooding drainage
of the terminal compartment for the connector system M12 must be guaranteed.
Direct installation of the spot into the substrate
The installation of the
brilliance-midi (narrow)
,
brilliance-mini
and
dome-spot
can be done directly
in all suitable materials that have the required strength for holding the recessed spot, e.g. wood,
concrete and natural stone. The spot is held by the lateral stainless steel springs inside the hole.
In most cases, an installation sleeve is not necessary. Observe the position of the spot and the
resulting stress on the material.
Drill the installation hole for the spot. The required borehole diameter is between 42 and 45 mm. In
case the spot is supposed to be installed in solid material, e.g. massive concrete wall, stone, scree
floor, the hole must be 50 mm deep plus the space for the respective cabling. A deeper hole facil
-
itates the accommodation of the excess supply cable when inserting the spot.
Important: Always
leave a small cable reserve, which makes it possible to pull the spot approx. 10 cm out of the
installation hole in the event of service.
In case the spot is exposed to loads, the surface on which the bezel of the spot rests must be level
and capable of bearing the load.
Installation of the spot with installation sleeve
The installation sleeve allows the installation of the
brilliance-midi
,
brilliance-mini
and
dome-spot
models in loose materials, e.g. floor joints, gravel or in cast concrete, mortar beds or the like. The
installation sleeve has an outer diameter of 45 mm. In addition, the mounting sleeve offers space
for the cabling of the lights, especially when arranged in rows with the M12 connector system with
Y-adapter.
Insert the installation sleeve into the substrate by pouring. The upper rim must be flush. In case the
spot is exposed to loads, the surface on which the bezel of the spot rests must be level and capable
of bearing the load.
21
en
Summary of Contents for brilliance-midi
Page 13: ...13 de Notizen...
Page 27: ...27 en Notes...
