ALZO 16x9 LED Pan-L-Lite Video Light User Manual
alzovideo.com [email protected] 800-582-7009
1770-IS
Included with the ALZO LED Pan-L-Lite are
•
TILT MOUNT
•
AC ADAPTOR
•
VELCRO CABLE TIES
Batteries and battery chargers are not included, and
they are sold as accessories.
Setup and Usage:
To install the lights on a light stand first screw the
stud pin mount 1/4” x 20 thread end into base of
the ALZO LED Pan-L-Lite as shown in figure 1.
Then put the tlit mount on the light stand, tighten
the tilt lock wing screw and finally assemble the
light to the tilt mount - figure 2. Adjust the tilt
angle and tighten all 3 wing screws.
Mounting the AC adaptor
The ALZO 500 16x9 LED light and the ALZO 800
16x9 LED light use different AC adaptors. The AC
adaptor for the ALZO 800 will operate the ALZO
500 but not visa versa.
Assure that the AC adapter is supported such that
the DC power cord is not taught when connected
to the light, The AC adapter includes Velcro cable
ties that must be used to support the AC adapter
on the light stand and prevent stress on the DC
connector and DC cable.
First make a loop with the thin DC wire close to
the AC adapter and attach a Velcro tie through the
wire loop as shown in figure 3, and then wrap the
Velcro around the light stand just above a section
clamp - figure 3. With the light stand fully
extended adjust the location of the Velcro tie on
the light stand to assure that the AC adapter thin
DC wire is not taught when the power plug is
connected to the power port on the LED light back
panel. Add a second Velcro cable tie below the
AC adapter as shown in figure 4.
Assure that the light power switch is OFF and
then plug the AC adapter AC cord into a mains
outlet. Turn on the light and adjust the intensity
level and color temperature.
figure 1
DC CORD
LOOP
VELCRO
CABLE TIE
VELCRO
CABLE TIE
VELCRO
CABLE TIE
figure 3
figure 4
figure 2
