1
Product overview
1.1
Overview
Fig. 1: Product overview
1
Connecting piece
2
Atomizer air control (R)
3
Horn air control (F)
4
End cap
5
Control air connection (C)
6
Spraying air connection (A)
7
Cap nut with seal
8
Air cap
9
Material connection (M)
10
Fastening bore
11
Housing
12
Leakage bore
1.2
Short description
The spray gun is intended for surface
coating in high pressure area. Compressed
air is used to apply material. The atomized
coating material is fed through high pressure
lines. The operation can be done with paint
circulation or tap line.
Use a nozzle with a suitable diameter,
depending on the requirement.
The following factors influence the spray jet
and therefore the result
Alignment of the air cap
The alignment of the air cap determines
the alignment of the spray jet.
Atomizer air pressure
The higher the atomizer air pressure, the
finer is the atomization and the smaller is
the spray pattern.
Horn air pressure
The higher the horn air pressure, the
softer the spray jet pattern edges
become.
Control air pressure
Opens the needle and controls the mate-
rial outflow.
Material pressure
The higher the material pressure, the
higher the material flow and thus the finer
the atomization. The lower the material
pressure, the higher is the efficiency and
the smaller is the overspray generated.
Nozzle
Product overview
02/2020
EcoGun AA AUTO - MSG00008EN
4/48
