56
Crane 4000LE
07-2022
RL6002-001
Crane 4000LE Installation Manual
In-ground Motion Assist 360 drive and speed control
Remote control enclosure
Chapter 13
13.2.1 Check bottom plug adapter alignment.
NOTICE
If bottom plug adapter cannot be centered in
the center section container lid hole, contact
Crane to resolve this issue before proceeding
with further container assembly.
1. Insert bottom plug adapter into speed control drive
shaft.
2. Install center section container lid and fasten with
two flat head screws RF6025-01G.
3. Check bottom plug adapter alignment in center
section container lid hole.
NOTICE
Bottom plug adapter checks.
• Bottom plug adapter must be centered in
center section container lid hole (Fig. 13.2.3).
• Bottom plug adapter must be plumb.
• Speed control mounting hole diameter is 7/16" so
slight adjustment is possible.
4. Once bottom plug adapter centered in hole, tighten
the speed control 3/8 x 7/8" SHCS (Fig. 13.1.3).
NOTICE
Insure that the three 3/8 x 7/8" SHCS are
securely tightened.
Fig. 13.2.2 Bottom plug adapter installed in speed
control drive shaft
Fig. 13.2.3
Center section container lid installed on
container
Fig. 13.2.1 Bottom plug adapter
13.2 Check bottom plug adapter and container lid alignment
1
RS6074-010
Floor speed control assembly
2
RC6069
Center shaft bottom plug adapter
3
RC6049
Center section container lid
4
RF6025-01G
1/4-20 x 3/4" flat head countersunk
seal screw
Table 13.2.1
In-ground container with bottom plug
adapter and container lid
2
2
3
4
4
2
Fig. 13.2.4 RF6025-01G
4
