07. INSTALL TRIM (IF USING) AND SECURE DEVICE CENTER CASE TO DOOR.
6
06. DETERMINE USE OF NIGHT LATCH (NL) DRIVE SCREW
05. INSTALL BOTTOM STRIKE
Pullman Latch
Round Bottom Latch
E
E
DXAS224
Strike
DXAS227
Strike
DXAS225
Strike
DXAS226
Strike
O
N
1. Mark floor for fasteners, prepare floor according to the
type of strike and fastener furnished. Provide clearance in
floor for bolt.
2. For threshold application: Provide hole in threshold
according to type of strike and fasteners furnished.
Removal Tool
(5/64" Hex Wrench)
NL driver screw is factory assembled in cam on back of device
center case, when the NL drive screw is left in back of center
case, the outside cylinder will function only as a Night Latch.
NOTE:
1.
DO NOT
remove NL drive screw for Pull Plate or
Escutcheon with night latch cylinder.
2.
REMOVE
NL drive screw from back of center case
when installing trim that has a functional lever,
knob, or thumbpiece AND an outside cylinder to
lock and unlock the trim.
Cam
NL Drive Screw
1. DEVICE WITH TRIM - See "Trim Instructions".
2. CYLINDER ONLY - Install cylinder with cylinder back plate as shown. Make sure the tailpiece is
extending 1/2" from the inside face of door. Insert tailpiece into cam in the center case and mount
it to the door with four(4) center case screws.
3. EXIT ONLY - Mount center case to the door with four(4) center case screws.
Center
Case
Screws
1-1/2" minimum clearance (with end cap
removed) if device is too long for door,
see "CUT DEVICE" on page 11.
Trim
(Optional)
Cut tailpiece if needed
Cylinder
Back Plate
Cylinder Screws
1/2"
C
