08. INSTALL MOUNTING BRACKET AND END CAP
09. INSTALL TOP LATCH AND ROD
09. INSTALL TOP LATCH AND ROD (SUITE)
7
2. Insert cover plate, slide anti-rattle clip in position
(2" minimum from end), and attach end cap with
two(2) end cap screws.
End Cap
Screws
End Cap
End Cap Bracket
Level Device
End Cap
Bracket Screws
C
J
1. Remove cover plate, insert end cap bracket into
push bar assembly against mechanism case.
Level device, mark and drill two(2) holes for Bracket
Screws. Fasten end cap bracket screws to door.
Cover Plate
Anti-Rattle Clip
2" Minimum
1. Install top latch with two(2) screws (sex bolts).
Adjust strike so that device latches without binding.
See Figure 1
2. Determine rod lengths as shown in
Figure 2
.
If necessary; cut end of rod and tap. See
"CUT TOP ROD / EXTEND TOP ROD" on page 10.
Top Latch
Latch
Screws
Sex Bolts
F
H
Figure 1
Sleeve
Top Latch
Amount
to
Cut Off
Actual
Door
Opening
Height
Figure 2
Figure 3
NOTE:
Match notch of
connecting bar with
tab of rod before
tighten connecting
screw.
Connecting
Bar
Rod
Connecting
Screws
Rod
Connecting
Bar
Connecting
Screw
Notch
Tab
Side
Screws
Second
Holes
Connecting
Bar
F
3. Put connecting screw through round hole of connecting bar
and thread into top rod and tighten.
See Figure 3
4. Assemble sleeve with rod. Thread top rod onto top
latch until first hole in connecting bar align with first
hole in retractor and fasten side screws.
