OPTIONAL DOGGING
11
CUT DEVICE (IF REQUIRED)
DOGGING CHECK
Depress push bar and turn flat / hex wrench or key one
full turn for dogging check.
Cylinder
Lock Nut
Slide cover plate in position in the mechanism case.
With cam toward hinge side install
the cylinder to the cover plate.
BOTTOM VIEW
CYLINDER DOGGING
Hinge
Side
Cylinder
Cylinder
Locating
Washer
Cam
Cover Plate
Cylinder Dogging
Flat / Hex Key Dogging
Recommended minimum clearance
between frame and device end
(with end cap removed) is 1-1/2".
Hinge
Side
2. Cut off device and deburr.
NOTE:
Device must be cut square
for proper end cap fit.
Center case aligned
with mounting holes.
End Cap
1. With anti-rattle clip removed, tape and mark area being cut.
Remove
Anti-Rattle Clip
Tape
Cut off line
Cover Plate
(Flush to Push bar)
