12. INSTALL BOTTOM LATCH AND ROD
39
1. Install bottom latch with two(2) screws(Sex bolts).
2. Put connecting screw through round hole of
connecting bar and thread into bottom rod and tighten.
3. Assemble sleeve with rod, thread the bottom rod
onto the stud in the bottom latch until the first holes
in the end of connecting bar align with first holes in
retractor and fasten side screws.
For less bottom rod (LBR) installations, omit preparation
for bottom latch and rod
Side
Screws
Rod
Sleeve
Latch Screws
Bottom Latch
Sex Bolts
Connecting Bar
F
Side
Screws
Retractor
Second
Holes
First Holes
L
H
13. ADJUST BOTTOM ROD WITH DOOR OPEN
(TOP LATCH RETRACTED).
14. INSTALL ROD GUIDES AND COVERS
WITH SCREWS.
1. Place device in holdback by pushing on push bar.
Bottom latch bolt clears bottom strike, adjust retractor
by screw driver or readjust rod if needed.
2. Secure two side screws when adjustment is completed.
Open and close door a few times and check for
proper latching when door is closed.
Close
Open
I
D
I
Position rod guides midway between latches and center
case, centered on rods. Mark, drill/tap and fasten rod
guides with two(2) screws.
Cover
Cover
Screws
Rod Guide
Latch Cover
Rod Guide Screws
Latch Cover Screws
Remove protective
film from push bar
Install rod guide
at mid point
between latches
and center case.
