OPERATION AND FUNCTIONS OF THE SUPER USER CODE
1) Operate Output 1 and 2
The operation of the Super User Code is just like a normal User Code. Simply key-in the Code
with a specific output number for the desired Output. The Super User Code can also be used to
reset an operating output timer instantly.
---------- Output 1 Activates or Resets
---------- Output 2 Activates or Resets
Optional Functions Controlled by Super User Code for Output 1
Apart from controlling of the two outputs 1 and 2; the Super User Code can also be used to
enable the optional functions controlling
Output 1
for user convenience or security enhancement.
Super User Code and Egress Button are excluded from any system inhibition and lockup
functions; they are valid for door open at anytime for safety.
2) Override The Door Lock Controlled by Output 1 (Keep Door Un-locked)
The Output 1 is usually for door lock control. In some situations, the door may require un-locked
for a period of time to allow door opening without User Code for entry / exit convenience. This
function Starts / Stops in toggle with the following code entry.
---------- The Door is Un-locked, Start / Stop in Toggle
NOTE :
3) Pause The Scheduled Daily Inhibition for Output 1 (Temporarily Disable The Inhibition)
The scheduled inhibition can be programmed and applied to Output 1 with daily start and stop
times. It can be stopped temporarily if required; such as the staff work overtime after office
hours going into the inhibition period. This function Starts / Stops in toggle with the following
code entry. It can be done before or during the inhibition period.
---------- Door Lock Operation Resumes, Start / Stop in Toggle
NOTE :
•
The “INHIBIT” LED (Red) is ON in inhibition and turns to Flashing while pause is into effect.
•
See
Programming Locations 55 & 56
for more information Daily Inhibition.
SUPER USER CODE
SUPER USER CODE
SUPER USER CODE
SUPER USER CODE
The door is un-locked while the function is enabled. The “Output 1” LED (Green) turns ON.
Do not
forget to stop this function after use because the door is un-locked. Also, the system
refuses the optional functions (3) & (4) while Override function comes into effect.
This feature is
good for all the “Fail-safe electric locks”.
“Fail-secure electric lock”
requires power to keep in un-locked condition. It takes high current all the
time while the function comes into effect and
may cause damage
to it. This function is not
recommended for Fail-secure electric lock.
17
Doorentryonline
Ltd
