DOMUSA TEKNIK BIOCLASS iC 150, Installation And Operating Instructions Manual

Page: 38 / 80

EN
38 BIOCLASS iC 150
11.3 Manual adjustment of the feed auger calibration
In this display you can manually adjust the feed auger calibration
value. Once the display "Manual adjustment of the calibration" (
)
from the
"Calibration Menu"
is selected by pressing the symbol we
can access it; SET will begin flashing and using the symbols " + " o " - "
of DHW
(21)
we can set the desired value. The range of setpoint
calibration is OFF, 5,000 – 9,900 kg.
11.4 Manual ash cleaning
This display is used to manually enable a number of ash cleaning
device functioning cycles up to a maximum of 20 cleans. On selecting
the "Calibration of the fuel feeder" display (
) from the
"Calibration
Menu"
by pressing the symbol we can access it and SET will begin
flashing. Pressing symbol again will start the manual ash cleaning
process, activating the countdown from 20 cleans.
Pressing you can stop the cleaning process at any time, and by
pressing RESET you can go back to the
"Calibration menu"
at any time.
11.5 Manual operation of the circulation pump
In this display we can manually operate the feed pump of the buffer
tank or needle. On selecting the "Manual operation of pump Bbt" (
)
from the
"Calibration Menu"
by pressing the symbol we can access
it and SET will begin flashing. Pressing the symbol again, the pumps
will start up and run for a maximum of 20 minutes.
By pressing we can turn off the pumps at any time, and by pressing
RESET we can return to the
"Calibration Menu"
at any time.
11.6 Calibration of the lambda probe
By calibrating the lambda probe we can adjust any deviations there may be in the lambda probe during
the measurement of the oxygen concentration.
On selecting the "Calibration of the lambda probe" display ( ) from the
"Calibration Menu"
by pressing the symbol we can access it and
SET will begin flashing. Pressing the symbol again will start the
calibration process. During the calibration process the signal will be
displayed in mV from the lambda probe. When the calibration process
is complete the value -7 mV will appear on the display.