3. INSTALLATION
Install the machine according to current regulations.
The installation must conform with local codes or, in the absence of local
codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54, or the
Natural Gas and Propane Installation Code, CSA B149.1
3.1.
Tools
Tools required for the installation:
1. No 13 flat or adjustable spanner
2. Flat-head screwdriver
3. Phillips head screwdriver
4. Level
5. Protective goggles
6. Protective gloves
3.2.
Location.
3.2.1. Transport and storage.
The machine must be transported always on its pallet and original packaging to guarantee its integrity.
Transport the machine to the definitive workplace.
Remove the packaging and make sure that it has not been damaged during transport.
The dryer must not be installed or stored in an area where it will be exposed to water and/or weather.
If the machine must be stored for a long time, cover it with its original packaging to protect it from
external agents and keep it in the optimum environmental conditions. It should also be disconnected
from the electricity network.
Once located in its definitive workplace, remove the pallet to which the dryer is attached at the back of
the base with 2 bolts, which can be removed with an adjustable wrench or a flat No 13 spanner. Keep
this pallet with the original packaging for possible and future movements. Do not push the machine or
clear obstacles without the package, the machine runs the risk of deformation and malfunctioning.
The drum does not have anchorages for transport.
- LOCATION OF BOLTS 1 AND 2
- UNSCREW USING A FLAT NO 13 SPANNER
12
