Domino D120i Blue IP, Product Manual

Page: 63 / 224

INSTALLATION INSTRUCTIONS
L025317 Issue 5 July 2014 2-21
The machine interface delivers inputs and outputs to control the print
process and provides status information. It can be used to
communicate with a PLC or to harness external NPN or PNP type
control elements.
Connector Type:
• IEC 60130-9 12 way male
Mating Cable Connector (IP67 Types):
• Lumberg: 032212
Pin description
Pin A +24VF - 24V floating
This pin offers 24V floating. The maximum current for X4 and X28 is 0.5A. In
case of an over-current an automatic resettable fuse protects the system.
Pin B GNDF - Floating Ground.
Pin C INP_COM - This pin is defined as common pin for all inputs.
Pin D LASER_START - Mark enable input.
A logic high level on this pin puts the system into print mode and resets
error messages. The laser is enabled.
Note: This input internally works in parallel to the other (X29 and X59)
Laser Start Inputs. Thus, applying of constant voltage at this pin
will suppress edges coming from the other Laser Start Inputs.
Pin E MARK_CTRL - Mark inhibit / release input
A logic high or low level at this input enables or disables the Print_Go signal
delivered by pin F of the X4, pin 2 of X29 or pin3/4 of X3. The active level
can be selected by software.
Pin F PRINT_GO - Print Start input
A rising or falling edge at this input starts the print. The active level can be
selected by software.
Pin G PROG_IN - Programmable Input
This input is prepared for future use.
Pin H OUT_+COM - Positive common