gpelectric.com | [page 21]
SHORE POWER
UNIT READINGS
INVERTER
ON/OFF
CHARGER
ON/OFF
ENTER / SET
BACK
UNIT SETUP
REMOTE SETTINGS
®
SHORE POWER
UNIT READINGS
INVERTER
ON/OFF
CHARGER
ON/OFF
ENTER / SET
BACK
UNIT SETUP
REMOTE SETTINGS
®
SHORE POWER
UNIT READINGS
INVERTER
ON/OFF
CHARGER
ON/OFF
ENTER / SET
BACK
UNIT SETUP
REMOTE SETTINGS
®
Temperature
Batt : 20.0°C
Trans : 30.5°C
Fets : 30.6°C
Unit Fault Code
No Fault
VAC OUT
120 V
60.0 Hz
The first value displays the AC voltage measurement at the inverters output
terminals.
When in inverting mode this reading is displaying the inverters output
voltage.
When in charging or AC pass through mode, the display is showing the AC
voltage that is passing through the
Inverter/Charger
from the AC power source
(utility or generator)
4. TEMPERATURE
Batt:
Displays the temperature of the
Inverter/Charger
battery temp sensor
which should be connected to the battery bank
Trans:
Displays the temperature of the main power transformer inside the
Inverter/Charger
.
Fets:
Displays the temperature of the field effect transistors (FETs) inside
the
Inverter/Charger
.
5. FAULT CODE
Menu Heading
Selections / Adjustments Range
Default Setting
Unit Setup
01 Search Watts
OFF, 5 - 50W
5W
02 LowBatCutOut
9.0 - 12.2 VDC
10.5 VDC
03 VAC Dropout
80 - 100V
85V
04 Max.Cha Time
0.0 - 25.5 HR
12.0 HR
05 Battery Type
Gel, Flooded, AGM 1, AGM 2, Custom
AGM 1
06 Charge Rate
50% (IC 2000); 40% (IC 3000)
80%
07 Final Charge
Multi-Stage, Float, Silent
Multi-Stage
08 ABS Chg Time
0.5 - 24.0 HR
2.0 HR
09 Equalization
Active/Inactive
Inactive
10 Rebulk Volt
12.0 - 16.0 VDC
12.1 VDC
1. SEARCH WATTS
The search watts feature helps save the battery power by reducing the
Inverter/Charger
output to search pulses when there is no detect-
able load.
This screen will display a code to compliment the audible beep that is emitted
when a fault has occured. If there are no faults, this screen will say
No Fault
.
4.5 UNIT SETUP MENU
OPERATION
Summary of Contents for Go Power! C Series
Page 31: ......
