Dometic Frigo, Operating Manual

Page: 19 / 416

EN
Frigo Operation
19
5.9 Standby cooling with electric motor (additional
equipment)
!
I
Switching on the standby cooling
The standby cooling may only be operated under the following conditions:
‡
The vehicle must be on even ground so that the condensation can drain away.
‡
The vehicle engine must be switched off and the ignition key removed.
‡
All loading area doors must be securely shut.
!
CAUTION!
‡
The safety cap of the device plug on the vehicle must always be
closed if the standby cooling function is not is use.
‡
Before connecting the cable, the available mains voltage must be
checked. It should be fused with at least 16 amps.
‡
The extension cable should be as short as possible and have a cable
cross-section of 3 x 2.5 mm². The length of the extension cable
should correspond to the distance between the vehicle and the
mains socket. If a cable drum is used for the connection for standby
cooling, it should be rolled out fully. Otherwise, the cable becomes
very hot and a cable fire can be the result.
NOTE
Periods of low voltage and strong power fluctuations can lead to mal-
function.
CAUTION!
‡
Before you start the vehicle again, you must disconnect the mains
cable from the socket on the vehicle.
‡
The 230 V connection of the standby cooling may only be operated
with a fault current protected switch with a nominal current of 30 mA
and an earthed, splash water-protected mains socket.
)ULJR2VERRN6HLWH'RQQHUVWDJ)HEUXDU