Dometic BUTTNER MT ICC 1600 SI-N, Installation And Operating Manual

Page: 18 / 140

18 4445103626
• Before starting the device, ensure that the
power supply line and the plug are dry.
• To be able to disconnect the device quickly from
the mains, the socket must be close to the
device and be easily accessible.
Health hazard
• This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they
have been given supervision or instruction con-
cerning use of the appliance in a safe way and
understand the hazards involved.
• Always keep the appliance out of the reach of
children.
• Children must be supervised to ensure that they
don’t play with the device
• Cleaning and user maintenance shall not be
made by children without supervision.
Risk of injury
• Lay the cables so that they cannot be tripped
over or damaged.
Explosion hazard
• Do not operate the device under these circum-
stances:
– Wet or damp environments.
– Vicinity of corrosive fumes.
– Vicinity of combustible materials.
– Risk of gas or dust explosion.
A
NOTE Damage hazard
• Do not expose the device to a heat source (such
as direct sunlight or heating). Avoid additional
heating of the device this way.
• Setup the device in a dry location where it is pro-
tected against splashing water.
• Do not install the device in a dusty environment.
• Make sure that the mounting surface is capable
of supporting the weight of the device.
• Use ductwork or cable ducts if it is necessary to
lay cables through metal panels or other panels
with sharp edges.
• Lay the cables so that they cannot be damaged
by the doors or the bonnet.
• Do not lay the 230 V mains cable and the 12 V
DC cable in the same duct.
• Do not lay the cable so that it is loose or heavily
kinked.
• Fasten the cables securely.
• Do not pull on the cables.
• Always use sockets which are grounded and
secured by residual current circuit breakers.
• Make sure that the lead has a sufficient cross-sec-
tion.
• Make sure the air inlets and outlets of the device
are not covered.
• Ensure good ventilation.
Scope of delivery
MT ICC 1600 SI-N
MT ICC 3000 SI-N
Quantity Description
1 ICC Inverter Charger Combination
1600 SI-N
1 Installation and operating manual
1 Battery temperature sensor with 3 m cable
and RJ12 plugs
4 Mounting screws
2 1.5 m battery cable with M8 lugs
1 5 m cable for remote control
1 Remote control
1 Wall mounting box for remote control
4 Mounting screws for remote control
Quantity Description
1 ICC Inverter Charger Combination
3000 SI-N
1 Installation and operating manual
1 Wall bracket
1 Battery temperature sensor with 3 m cable
and RJ12 plugs
2 M10 crimp terminals
7 Mounting screws
1 5 m cable for remote control
1 Remote control