Page 5
Leak Sensor Advanced User Manual
Specifications
Package Contents:
Technical Specifications
Radio protocol
Z-Wave(500 series)
Power supply
Single CR14250 3.0V battery
Power Consumption
0.13W
Working current
35mA
Operating temperature
32—104 °F (0—40 °C)
Radio frequency
908.4 MHz US
Range
Up to 150’ depending on environment
Dimensions (L x W x H)
SENSOR ASSEMBLY: Ø2.63” x 1”
Table 1 -
Technical Specifications
SolidWorks Student Edition.
For Academic Use Only.
USER MANUAL
SENSOR ASSEMBLY MAIN BODY CRADLE
BATTERY
REMOTE SENSOR PROBE
1xSCREW
1x WALL ANCHOR
Thank you for your purchase of the DOME
Leak Sensor, a device which allows you to
monitor your home for leaks and alerts you via a
signal to your Z-Wave Controller and an audible
alarm when water is detected.
LED Indicator
Cradle
Lead
Remote Sensor
Metal Feet
Note: Requires the DOME Hub or any other Z-Wave certified Hub
for use
Figure 1 - Leak Sensor Front
Set Up—DOME System:
1. Pull up the DOME App on your Smart Phone.
2. Open the Side Menu ( ), then select the
option “Add New Device.” The App will then
take you step-by-step through connecting the
Leak Sensor to your system.
Figure 2 - Including in the Dome App
Set Up—Non-DOME System:
Follow the instructions for your Z-Wave certified Controller
to enter inclusion mode.
When prompted by the Controller:
1. For proper inclusion, bring the Leak Sensor to within
10 feet of your Controller. After inclusion, the device
can be moved to any desired location.
2. Remove the cover of the Leak Sensor by twisting it
apart and remove the Battery Tab.
3. Press the Connect Button quickly 3 times in a row.
The LED Indicator will flash five times indicating inclusion.
Battery Tab
LED Indicator
Connect Button
Battery
Figure 3 - Inside the Leak Sensor
Excluding/Disconnecting from the Z-Wave Network:
Follow the instructions for your Z-Wave certified Controller to
enter exclusion mode.
When prompted by the Controller:
1. Remove the Cover of the Leak Sensor.
2. Press the Connect Button quickly 3 times in a row.
The LED Indicator will flash five times indicating exclusion/dis-
connection.
Resetting the Leak Sensor to Factory Default Settings:
The Leak Sensor may optionally have some of its settings changed
to alter its behavior. To clear these settings, disconnect from the
Z-Wave Network, and restore factory default settings:
1. Open the Back Plate and make sure the Leak Sensor is
powered.
2. Hold the Connect Button for 10 seconds until the LED Indicator
blinks once, then release the button.
The LED Indicator will flash once indicating factory reset.
Only do
this if the controller is disconnected or otherwise unreachable!
How to Use—Without Cradle:
You can use the Leak Sensor to monitor most appli-
ances and pipes for leaks without the cradle. Once
included in your Z-Wave system, place the Leak Sensor
on a flat surface near the item you want monitored
where water will collect if it leaks. Make sure all three
Metal Feet are touching the surface.
Metal Feet
Leaking Water
Sensor
When water contacts the
Metal Feet, it will beep
and send an alert to your
Z-Wave Controller notifying
it of the detected water.
Figure 4 - Using the Sensor
Without the Cradle
Figure 5 - Showing the
Metal Feet
Leak Sensor
Specifications