Page 10
Leak Sensor Advanced User Manual
Physical Installation
Installation—Without the REMOTE SENSOR PROBE
1. Make sure the Leak Sensor is already included in your Z-Wave System and
bring it to your desired installation location.
2. Confirm that your device can communicate with your Z-Wave Controller from
the final installed location before proceeding.
3. Place the SENSOR ASSEMBLY on a flat surface near the device to be moni-
tored (see “Pre-Installation Checklist” on page 9 for proper placement in-
structions.)
4. Double-check that your Z-Wave Controller can still communicate with the
Leak Sensor, and pour a small amount of water on the floor to emulate a leak
and confirm that the device beeps and reports the event to your Controller.
Installation—With the REMOTE SENSOR PROBE
Hard to reach areas can be monitored for leaks using the included
REMOTE SENSOR PROBE (see “Pre-Installation Checklist” on page 9.)
1. Mount the MAIN BODY CRADLE on a wall near the location you wish to moni-
tor, making sure the REMOTE SENSOR PROBE’s cable will reach it comfortably.
You may optionally rest the MAIN BODY CRADLE, unmounted, on a table, shelf,
or other surface.
2. Snap the SENSOR ASSEMBLY into the MAIN BODY CRADLE, making sure
the METAL FEET on the SENSOR ASSEMBLY line up with their mates on the
MAIN BODY CRADLE.
3. Plug the REMOTE SENSOR PROBE into the MAIN BODY CRADLE and place
the other end of the PROBE in the area to monitor, making sure the METAL FEET
are flat on the surface.