Dolmar MS-26 C, Instruction Manual

Page: 10 / 156

10
CAUTION: Before doing any work on the brush cutter, always stop the engine
and disconnect the spark plug connector from the spark plug.
Always wear protective gloves!
CAUTION: Ensure you have reassembled the brush cutter completely before
starting it.
For U Handle models
– Place the handle-fixing metal so that the handle with the control lever is
positioned on the right (the right-hand grip side) when viewed from the engine
side.
– Fit the groove of the handle-fixing material to the handle end. Temporarily fix
the attached metal using the hexagon socket bolt provided.
– Adjust the handle to an easy-to-operate position, and securely tighten the four
hexagon socket bolts uniformly on the right and left using an Allen key.
– Fit the control cable (together with the earth cord) to the handle with two clips
(1).
– Make sure the control cable does not loop at the handle bar section.
For Loop Handle models
– Fix the barrier to the left side of the equipment together with the handle to
protect the operator.
– Do not adjust position of the loop handle too close to the control grip.
– Keep a distance of at least 250mm between the handle and the grip. (a
distance collar is provided for this purpose.)
Mounting the handle
MS-26 U
(1)
MS-26 U
MS-26 C
to Engine