3 Installation of Dolby Object
Authoring Tool DP590
This section provides procedures for installing the Dolby Object Authoring Tool DP590.
•
•
•
Downloading and installing DP590 client
•
3.1 Installing hardware
Install the DP590 using the components included with the unit, plus any other equipment
you require for your intended use. After the unit is installed, proceed to configuration and
full operation.
Procedure
1. Rack mount the DP590 in a 1-U rackspace. The DP590 measures 44 × 483 × 394 mm (1.75
× 19 × 15.5 inches), so the rack must be at least 400 mm (16 inches) deep.
Caution:
To ensure proper ventilation, do not block the front-panel ventilation area
on the top surface at the front of the machine.
2. Connect the provided power cable to the AC connector.
3. Connect your audio and video inputs and outputs.
4. Connect an Ethernet cable from your network to the
Command
port.
5. Turn on the device by pressing the power button.
3.2 Configuring network settings
The DP590 uses a
COMMAND
port network connection; the port can be configured using
front-panel navigation keys.
About this task
The port connects to your management network through a client application. By default, the
COMMAND
port is set to Dynamic Host Configuration Protocol. Configure the port using the
front-panel navigation keys shown in this figure.
Figure 3: Front-panel navigation keys
Installation of Dolby Object Authoring Tool DP590
Dolby Object Authoring Tool DP590 quick-start guide
Preliminary 10 May 2017
12
