Installation
- 4 -
Startup
1)
Connect AC power adapter
2)
HQR1 DVR will start a self-diagnostics when power on
3)
The LED is red in self-diagnostics and will turn yellow on start-up. The LED
turns to green once start-up is successful.
It takes about 12 seconds to start-up
4)
The LCD displays
Init…
during startup, after startup is successfull, the
LCD will display
DCS HQR1
5)
You will hear a beep once the HQR1 DVR starts-up
The Vibration Motor will vibrate one time once when DCS HQR1 DVR
starts-up successfully
*
6)
The battery will be charged automatically when power on and LED turns to
red
The battery should be fully charged before first use. The charging LED goes out
once charge finished.
Please charge the internal Li-Ion battery over night & until the charging LED
goes out. Li-ion rechargeable battery is expendable.
The battery should be replaced after 500 charge cycles. The used battery should
be disposed of properly.
* The Beep & Vibration Motor is only one in DCS HQR1 DVR, The Beep is standard
part, Vibration Motor is optional only for special model.
Safety and Warning
* Never connect IRIS-Power output to any power adapter. It may damage the
interface and board.
* There are no user serviceable parts, please do not open the unit. Doing so can
damage the unit and will void your warranty.
* Restrict input voltage to a range from 9V to 15DC, 12V DC is recommended. Never
apply DC voltage beyond this range or AC voltage to the DCS HQR1 DVR.
* Only use AC power adapter supplied with the unit. Do not use third party AC
power adapters, it may cause unexpected problems or damage.
* Restrict powering devices drawing more than 200mA current.
* Never insert or remove CF cards the while the power is on.
