Active groups can be displayed by using the Dupline bus. To do this,
the groups must be linked to addresses.
2. Saving lighting scenes
a) Combine the groups into lighting scenes (16 scenes max.) (see
Section 5.7.2 “Creating lighting scenes” on page 28)
b) Use a Dupline address to link the lighting scenes
Individual group parameters are factory defaults but the following values
can be adjusted separately for each group:
1. Minimum brightness down to which lighting should be dimmed (see
Section 5.6.3 “Configuring lighting groups” on page 23)
2. Maximum brightness up to which lighting should be brightened
3. Dimming speed for manual smooth adjustment of lighting (see Sec-
tion 8.2 “Dimming/fade speeds” on page 41)
4. Fade speed when changing the brightness by calling up lighting
scenes and central commands (see Section 8.2 “Dimming/fade
speeds” on page 41)
12
Doepke