Docomo FOMA D905I, Manual

Page: 45 / 513

43 Voice/Videophone Calls
2
n
(voice call) or
t
(videophone call)
You will hear a dial tone. You can start talking
when the call is answered.
･
If the other party is busy, you will hear a busy
tone. Press
f
to end the call and call again
later. You can call again quickly using Redial.
･
While a videophone call is being connected, your
image is displayed on the screen.
･
For a videophone call, charging begins when
Connected to videophone
. appears.
･
The other party’s voice comes out of the speaker
during a videophone call.
･
For a videophone call, the substitute image may
be displayed depending on the other party’s
settings.
3
f
to end the call
INFORMATION
[Common]
●
If you hear a guidance requesting your caller ID when
making a call, call again after setting the FOMA terminal
to send caller ID.
☛
P40
● When you have subscribed to the Multi Number service,
you can call after selecting a registered multi-number.
☛
P383
●
In the dual mode of 2in1, a screen appears prompting
you to select the number from which you are calling.
Select
Number A
or
Number B
.
[Voice call]
●
You can also make a voice call in order of Step 2 and
Step 1. A voice call will be made automatically about 5
seconds after you have pressed
n
and entered the
phone number.
[Videophone call]
● If a videophone call is not connected, one of the following
messages appears on the screen and then the standby
display reappears. Note that the displayed message may
not reflect the status of the other party’s terminal
correctly, depending on the type of the terminal or the
network service used by the other party.
*1 The message may also appear when the other party
is in packet communication, depending on his or her
terminal.
●
If a videophone call failed to be connected while
Auto
redial as voice
is set to
ON
, the call is automatically
redialed as a voice call. If redialing as voice call occurs,
voice call charges apply.
●
Please note that digital communication charges apply to
videophone calls instead of voice call charges even if the
substitute image or Chara-den is used.
Voice call
Videophone call
Talking screen
Talking screen Connecting screen
･
The following operations
are available during a
voice call:
･
To display received
calls:
l
･
To display redials:
r
･
To open the phonebook:
p
Message Description
Busy.
The other party is busy.*
1
Redial using
voice call
.
This message appears when the other
party has activated Call Forwarding
Service with the forwarding destination
set to a terminal incompatible with
videophone.
Upper limit
exceeded.
Connection
failed.
This message appears when the limit
is exceeded for a billing plan with a
charge limit (such as Type limit and
Family Wide limit).
Connection
failed.
Set Caller ID Notification to
Notify
and
dial again.
･
The message may also appear in
cases other than the above.
Out of service
area/power
off
.
The other party is outside the service
area or the other party’s terminal is
turned off.
Busy with
packet
transmission.
The other party is in packet
communication.
Set Caller ID
to ON.
This message appears in case of
connecting without notifying the caller
ID (when accessing to visualnet).
Check
number, then
redial
.
You dialed the phone number not
used.
Make call
from i-mode
web page.
This message appears when using
V-live. Access to the IP site via i-mode
then make a videophone call on the
site screen.