DoAll C-3028NC Boxed, Instruction Manual

Page: 38 / 45

33
LUBRICATION
LUBRICATION CHART
LUBRICATION
POINT #
LOCATION DESCRIPTION AND SERVICE
RECOMMENDATIONS
LUBRICATION
INTERVAL

RECOMMENDED
LUBRICANT
1 Idler wheel bearing . One grease nipple. WEEKLY Premium quality, multi‐purpose
Lithium‐base, EP (extreme pressure)
grease.
Shell Alvania EP‐0
2 Index vise movable jaw ways . Two grease
nipples.
WEEKLY
3 Gearbox shaft bearings . Two grease nipples. WEEKLY
4 Band tension slide . One grease nipple. WEEKLY
5 Saw head tube . One grease nipple. MONTHLY
6 Sensing arm . Clean and apply oil. MONTHLY High quality, rust and oxidation‐
inhibited, medium hydraulic and
general purpose industrial oil.
ISO‐VG grade 68
Shell Tellus 68
7 Miscellaneous: vise slide, hinges, pivot hinges,
component parts, unpainted surfaces, etc.
To ensure function and maintain appearance
while reducing wear, corrosion, rust, etc. Apply
when and where needed in amounts required.
AS REQUIRED
8 Saw guide adjustment screws . Clean and apply
oil.
INSERT CHANGE
9 Band drive gearbox .
Capacity depending on model. See specification
chart. Drain, change and refill after first three
months, every six months thereafter. Do not
overfill. Fill until above red line on side gauge.
CHANGE AFTER
INITIAL THREE
AND FURTHER
SIX MONTHS Premium gearbox oil.
Contact DoALL Europa for proper oil
type. This varies depending on
model.
10 Electric and hydraulic motors .
Band drive, hydraulic pump motor, coolant pump
motor, chip auger motor.
Lubricate (if any) per manufacturer’s recommendation.
11 Coolant reservoir .
Capacity depending on model. See specification
chart. Drain, clean and refill whenever coolant
becomes undesirable for further use. Clean the
mesh screen at the same time.
CHECK DAILY /
REFILL AS
REQUIRED
Premium quality, saw band coolant
and lubricant.
DoALL cutting fluids or oils. (Kool‐
ALL / KleenKool)
12 Hydraulic reservoir .
Capacity depending on model. See specification
chart. Check fluid level daily and keep the
reservoir full. Drain, change the filter element
and refill after one month and every six months
thereafter.
CHECK DAILY /
CHANGE AFTER
INITIAL ONE
AND FURTHER
SIX MONTHS
High quality hydraulic oil.
ISO‐VG grade 32
Shell Tellus 32

Lubrication intervals are based on an 8‐hour, 40‐hour week.
Lubricate more often with heavier use.