DoAll C-3028NC Boxed, Instruction Manual

Page: 42 / 45

37
WEAR PLATE REPLACEMENTS (Continued….)
Vise jaw wear plates
1. The machine has eight (8) vise jaw wear plates: four
(4) on the front vise jaws and four (4) on the index
vise jaws. All wear plates are mounted with low‐
head screws. Be sure the vise jaws are separated
and the machine turned off before trying to replace
the wear plates.
Vise guide rails
1. Each of the two (2) vise guide rails for both front
and index vises has eight (8) mounting screws which
must be removed. Replacement requires: (a)
removing the mounting screws; (b) pulling the
guide rails towards the left.
BAND WHEELS
1. Occasionally check each band wheel’s back‐up
flange and wheel thread for wear. Saw band will not
track properly if the taper is worn from the wheel
thread.
2. Replace the entire band wheel if the rim becomes
badly worn.
3. Ideally, the saw band should be tracking on both
wheels so that the back edge will just lightly contact
the wheel flanges or run‐off maximum 1 to 2 mm.
CLEANING CHIP CONVEYOR
1. To clean the chip conveyor, turn the machine off.
Then: (a) disconnect the hydraulic hoses; (b) pull
the auger from its cradled position in the machine
base; (c) clean the chip conveyor trough; (d) clean
the reservoir floor; (e) reinstall the auger and the
cover.