15
2.
Remove the chip pan and dispose of the chips when
necessary.
3.
Metal chips and other waste materials may
collect around areas such as: saw guides,
table surface, T-slots, bandwheels, slides, etc.
Remove these materials as soon as possible.
The
DoALL Company recommends removng chp
collectons at least twce per each eght (8) hour
shft, and more often wth heaver use.
BAND DRIVE BELT
1.
The belt driving the input sheave will stretch during
use. This stretch should be taken up by moving the
drive motor on its mounting plate.
2.
To replace the belt:
(a)
Loosen the screws that
mount the drive motor and slide the motor to the
left;
(b)
Slip the old belt from the pulleys and install
the new one;
(c)
Slide the drive motor to the right
to tighten the belt so there is very little deflection of
the belt;
(d)
When correct belt tension is acheived,
tighten the screws.
MIST COOLANT
1.
Intermittent coolant stream indicates an air leak.
Check all joints.
2.
Clogging may occur if waxed-based or other
coolants are used. Your DoALL sales representative
can provide complete information about various
coolants.
3.
Keep the mist applicator nozzle and filter clean.
If the center nylon coolant tube needs replacing,
remove the entire applicator tube. Insert new nylon
tube and trim off excess flush with nozzle. Make
sure all joints are sealed and tight after applicator
tube is reinstalled.
BAND MIST LUBRICATOR
1.
Follow the manufacturer's maintenance instructions
for the lubricator. These instructions are located in
a pocket inside the electrical box enclosure.
MACHINE CLEANING (Continued....)
