TR-40CRA D
IGITAL
-
TO
-A
NALOG
TV C
ONVERTER
S
YSTEM
S
ETUP
Page 17
System Setup—Inactivity Standby
Inactivity Standby automatically turns off your TR-40CRA converter when it has
not been used for a specified number of hours (default is four hours). It is
recommended to leave this setting on Enable, as it allows the receiver to
perform basic maintenance. Basic maintenance may delay or interrupt Inactivity
Standby. If Inactivity Standby is interrupted, the green light on the TR-40CRA
converter will be lit briefly.
To change or disable this feature, select
Inactivity Standby
from the System
Setup menu.
•
Select
Enable
to turn this
feature on or
Disable
to turn
this feature off.
•
Adjust how long your TR-
40CRA converter waits
before automatically turning
off by changing the setting
under
Inactivity Duration
.
System Setup—System
Information
The System Information screen
displays technical information
about your TR-40CRA converter.
To open the System Information
screen, select
System
Information
from the System
Setup menu, or press the SYS
INFO button on the TR-40CRA
remote control.
System Setup—Factory
Defaults
Use Factory Defaults to reset
your converter to its original
settings. Select
Factory
Defaults
from the System Setup
menu. A pop-up window appears—select
Yes
to reset to Factory Defaults.
Note
: You will need to rescan your channels (see page 16) after resetting
factory defaults.
Inactivity Standby
System Information Screen
Resetting Factory Defaults
tr40.book Page 17 Thursday, August 14, 2008 12:47 PM
