TR-40CRA D
IGITAL
-
TO
-A
NALOG
TV C
ONVERTER
TR-40CRA T
OP
T
IPS
Page vii
Q
UICK
T
ROUBLESHOOTING
T
IPS
If You Get a Black or Blank Screen
•
Make sure your TR-40CRA is powered on. There should be a green light
on the front panel of the TR-40CRA converter. If not, press the POWER
button on your TR-40CRA remote control.
•
Make sure your TV is on the correct channel for viewing your TR-40CRA.
Your TV needs to be on either channel 3 or 4 (if connected using coax
cable) or a video input (if connected using RCA cables).
•
Your TR-40CRA might need a simple "reset". Simply unplug the TR-
40CRA from your power outlet for 30 seconds and then plug it back in.
Your TR-40CRA will reset and should be ready to use again within minutes.
Not Receiving a Digital Signal During Your Installation/
Set Up
Please note: Not all broadcasters are currently broadcasting a digital signal and
the source of the digital signal may move at any time. Go to
www.antennaweb.org or contact your local broadcaster to find out which
channels in your area are broadcasting a digital signal.
•
If you are not able to receive a
digital TV signal for ANY of your
local channels and you see "The
receiver is unable to detect a
signal in your area" message on
your screen, it is possible that
you do not have the correct over-
the-air antenna to receive a
digital signal or are out of range
for digital broadcasts. Go to www.antennaweb.org for more information on
which over-the-air antenna is best for your area or visit your nearest
electronics retailer.
•
If you are not able to receive a digital TV signal for SOME of your local
channels you may simply need to adjust your over-the-air antenna or get
an over-the-air antenna that is optimized for your area. Go to
www.antennaweb.org for more information on which over-the-air antenna
is correct for your area or visit your nearest electronics retailer.
Top_Tips.fm Page vii Monday, September 15, 2008 7:25 AM
