Dish Network 301 IR 123271, Manual

Page: 8 / 46

7
5. Press the POUND ( # ) button.
If you entered the address correctly, the
SAT
mode
button will flash three times.
6. Press the RECORD button. If you are using the 4.0
remote with the green 1 key (no UHF Pro marking),
point the remote control at the receiver when you
press the
RECORD
button.
7. Make sure the System Information screen shows the correct
remote address as follows:
• If only one Remote Address is shown, make sure this
address matches the number you entered in step 4.
• If you are using 4.0 remote with the green 1 UHF Pro key,
make sure that the
Primary Remote Address shows
UHF Pro and IR and that this address matches the number
you entered in step 4.
•
If you are using 4.0 remote with the green 1 key (with no
UHF Pro marking), make sure that the
Primary Remote
Address shows IR and that this address matches the
number you entered in step 4.
• If you are using 4.0 remote with the blue 2 UHF Pro key,
make sure that the
Secondary Remote Address matches
the number you entered in step 4.
8. Close the System Information screen. On most receivers,
this is done by selecting the Done button. See your receiver
user's guide for more information.
C
HECKING THE
R
EMOTE
A
DDRESS
To read out the remote control address setting:
1. Press and hold the SAT mode button for three seconds
until all mode buttons light. Then, let go.
2. Press the
POUND
(
#
) button twice while watching
the SAT mode button.
3. Count the number of times the SAT mode button
flashes. This number is the remote address. For
example, if the
SAT mode button flashes 6 times, this
indicates the remote address is set to 6.
text_dishnondvr.fm Page 7 Monday, November 7, 2005 12:03 PM
Downloaded from www.Manualslib.com manuals search engine