31
31
ESIM022 User manual v1.1
11. OUTPUT
The system comes equipped with 1 open collector output C1 designed for electricalal appliance
connection. Normally, the output can be used to arm/disarm a non-GSM alarm panel that has a
zone configured as key-switch. The ouptut can also be used to open/close garage doors, activate
lights, heating, watering and much more. When output turns ON, the system triggers any device
or relay connected to it.
When input Z2 is operating in Temperature Sensor mode, C1 converts to +4V power supply output
terminal for temperature sensor connection. In such case C1 terminal can not be used as open-col-
lector output. For more details, please refer to
8.2.2. Temperature Sensor Mode.
For more details on how to wire the output, please refer to
2.3. Wiring Diagrams.
11.1. Output Name
The output has a name that can be customized by the user. Typically, the name specifies a device
type connected to the output, for example:
Lights
.
By default, output C1 name is Output. To rename the output, please refer to the following config-
uration methods.
Rename output
SMS
SMS text message content:
TOUT:out-name
Value:
out-name
– up to 23 characters output name
Example:
TOUT:Lamp
Config
Tool
This operation may be carried out from the PC using the
ELDES Configuration Tool
software.
View output
name
SMS
SMS text message content:
STATUS
Example:
STATUS
Config
Tool
This operation may be carried out from the PC using the
ELDES Configuration Tool
software.
ATTENTION:
Colon, dash, comma characters are NOT allowed in the output name.
For more details on how to view system’s information that may include output name, please refer
to
13. SYSTEM INFORMATION. STATUS SMS.
