Version 1.0.0 12/16/2016
•
If the user selects Setup Instructions the instructions screen is displayed.
4) Select the placement for the WVB
Select a location for the WVB
•
Best location to provide GREE
(use 5 walls and 80 feet as the guide)
•
Access to the coax SWiM network. Do not connect the W
network yet.
5) Power on the WVB
up to a state referred to as ‘Survey mode’ or
transmits a signal for
sequence is as follows:
•
WVB2 LED
•
The boot up takes approximately two minutes.
•
Once boot up has completed, the WVB
•
The WVB2
Wireless Video Bridge S
that have not previously been paired (factory
reset to factory defaults.
6) The signal strength on every wireless client (
checked by ensuring that the Network LED
User Manual –
Wireless Video Bridge Gen 2
Page 18
If the user selects Setup Instructions the instructions screen is displayed.
FIGURE 6: C41W SIGNAL STRENGTH SCREEN
the placement for the WVB2
Select a location for the WVB2 based on the following factors:
Best location to provide GREEN LED to all wireless clients(
(use 5 walls and 80 feet as the guide)
Access to the coax SWiM network. Do not connect the W
network yet.
on the WVB2 and observe the power up sequence.
up to a state referred to as ‘Survey mode’ or ‘Beacon
transmits a signal for wireless clients (C41W, C61W)
sequence is as follows:
LED flashes BLUE during boot up.
The boot up takes approximately two minutes.
Once boot up has completed, the WVB2 LED alternates GREEN/YELLOW.
2 is now in Video Bridge Survey/Beacon mode.
Wireless Video Bridge Survey/Beacon mode works only on WVB
that have not previously been paired (factory fresh) or client
reset to factory defaults.
The signal strength on every wireless client (C41W, C
checked by ensuring that the Network LED is GREEN
Wireless Video Bridge Gen 2
If the user selects Setup Instructions the instructions screen is displayed.
based on the following factors:
N LED to all wireless clients(C41W, C61Ws)
Access to the coax SWiM network. Do not connect the WVB2 to the coax
and observe the power up sequence. The WVB boots
Beacon Mode’ where it
1W). The WVB boot
LED alternates GREEN/YELLOW.
mode.
mode works only on WVB2 and clients
) or clients that have been
C61W) should be
is GREEN
