User Guide
P. 11
•
to lock the doors and shut down the engine;
•
to unlock the doors and shut down the engine;
•
to shut down the engine without affecting the doors.
8.
The
icon will appear on your screen.
Remote
Starting
1.
Press the button for approximately 1 second and release.
2.
The remote will beep once and the LCD will display “START”.
3.
The remote will confirm the remote starter’s activation by beeping 3 times.
If your vehicle has an automatic transmission and it does not start at the first attempt, the system
will shut down, wait a few seconds and try to start the engine again. There will be 3 start attempts
before the system gives up.
Driving
Off
With the vehicle running under remote start, press the
button to disarm the security system
(this will also unlock the doors). Enter the vehicle and do the following:
1.
Turn the ignition key to the
IGNITION ON (RUN)
position. (Do not turn the key to the
CRANK
position
while the engine is running. This would cause the starter motor to re-engage.)
2.
Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.
Arming
and
disarming
of
the
System
The Alarm can be configured by the installer either to Passive Mode (so as to arm automatically)
or Active Mode (so as to require the user’s intervention for arming). By default, the Remote Car
Starter is configured to Passive Mode.
Passive mode:
To arm the alarm, press the
button on the transmitter, OR
1.
In Passive Mode, the alarm will automatically arm 30sec once the last door is closed.
2.
The LED on the antenna will flash quickly during the countdown preceding the activation
of the system.
3.
Once the activation countdown expires, the siren will chirp once and the LED will flash
slowly to indicate that the alarm is now armed.
To disarm the alarm, press the
button on the transmitter.
1.
The LED on the antenna will flash quickly during the countdown preceding the activation
of the system.
2.
The alarm will automatically rearm itself after 30sec if no door is left opened and the
ignition is not turned ON.
Active Mode:
To arm the alarm, press the
button on the transmitter.
1.
The siren will chirp once.
2.
The LED on the antenna will flash slowly.
To disarm the Alarm, press the
button on the transmitter.
1.
The siren will chirp twice.
2.
The LED on the antenna will remain OFF.
