User Guide
P. 13
Idle
Mode
Convenience feature: Idle Mode allows you to keep the engine running and the doors
locked while you stop, for example, at a convenience store or for a short delivery. (remove
this part for IG)
This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the
Ignition Switch) while the engine is running.
If your vehicle has an automatic transmission, proceed as follows to set the system to Idle Mode:
1.
With the engine running, make sure to release the brake pedal and press the
, or
button on the transmitter until the parking lights come ON.
2.
Remove the ignition key from the ignition switch.
The engine will continue running.
3.
Exit the vehicle and close all doors, hood and trunk.
4.
Press the
button to lock the doors, to arm the starter kill and to arm the alarm.
If your vehicle has a manual transmission, Idle Mode can be activated through the same routine as
that used for Ready Mode (page-10); at the last step, the
button is pressed instead of the
other buttons. This will lock the doors, arm the system and leave the engine running.
Note 1: The engine will continue running until the user re-enters the vehicle or until the expiration
of the engine run time.
Note 2: If the pre-programmed run-time expires or if the user shuts down the engine by remote
control, the vehicle will enter Ready Mode.
Caution!! Do not leave children or pets unattended in a vehicle standing in Idle Mode.
Valet
Modes
When the vehicle is in Combo Valet and Valet Start, the remote starter is disabled. If the vehicle
needs to be serviced, or if you park it indoors, the Combo Valet and Valet Start will prevent the
engine from being remote-started accidentally.
There are 3 types of Valet Modes: Combo Valet, Valet Start and Valet Alarm.
•
Combo Valet: Both remote starter and alarm are disabled.
•
Valet Start: Only the starter function is disabled.
•
Valet Alarm: Only the alarm functions are disabled.
1)
To
put
the
system
into
Combo
Valet
a)
To put the system into Combo Valet mode using the KEY:
i)
Insert the ignition key into the ignition switch. Within 10 sec., turn the key 5 times
successively into the IGNITION/RUN and OFF positions.
ii)
The parking lights will flash three times.
iii)
Turn the ignition OFF.
iv)
The LED on the antenna will come ON solid to indicate that the vehicle has
successfully entered Combo valet.
v)
Press any command to refresh the screen; the
icon will appear on your LCD
remote.
b)
To put the system into Combo Valet mode using the TRANSMITTER:
