4
HINGING THE ELEVATOR.
Glue the elevator hinges in place using the
same techniques used to hinge the ailerons.
HINGING THE RUDDER.
Glue the rudder hinges in place using the
same techniques used to hinge the ailerons.
TURNBUCKLE INSTALLATION.
The hole location of turnbuckle shown in
picture below.
Attach the thread to the servo lead and
carefully thread it though the wing.
The mounting holes of turnbuckle was
pre-drilled at factory.
Installing the turnbuckle for tail strut of
horizontal fin as same as pictures below.
.
INSTALLING THE AILERON SERVO.
1) Install the rubber grommets and brass
collets onto the aileron servo. Test fit the
servo into the aileron servo mount.
Because the size of servos differ, you may
need to adjust the size of the precut opening
in the mount. The notch in the sides of the
mount allow the servo lead to pass through.
Work the aileron up and down sev-
eral times to “work in” the hinges
and check for proper movement.
Note :
3x20mm.
32mm
Tail fin bottom.
Horizontal fin bottom.
Turnbuckle.
Wing bottom.
