6
Repeat the procedure for the other aileron
servo.
INSTALLING THE FUSELAGE SERVOS.
Because the size of servos differ, you may
need to adjust the size of the precut opening
in the mount. The notch in the sides of the
mount allow the servo lead to pass through.
2) Install the rubber grommets and brass
collets onto the throttle servo. Test fit the
servo into the aileron servo mount.
3) Secure the servos with the screws provid-
ed with your radio system.
1) Locate and cut out the covering film from
the servo holes in both sides of fuselage.
HORIZONTAL STABILIZER.
1) Using a ruler and a pen, locate the center-
line of the horizontal stabilizer, at the trailing
edge, and place a mark. Use a triangle and
extend this mark, from back to front, across
the top of the stabilizer. Also extend this
mark down the back of the trailing edge of
the stabilizer.
2) Using a modeling knife, carefully remove
the covering at mounting slot of horizontal
stabilizer ( both side of fuselage).
3) Slide the stabilizer into place in the precut
slot in the rear of the fuselage. The stabilizer
should be pushed firmly against the front of
the slot.
Wire keeper.
Servo arm.
Right side.
Remove covering.
Right side.
Left side.
Elevator servo.
Rudder servo.
Center line.
