10
MOUNTING THE CONTROL CLASP.
1) Align the tail wheel wire so that the wire
is parallel with the bottom of the rudder. The
control clasp has a predrilled hole through
the top of it. Slide this hole onto the tail
wheel wire while sliding the clasp over the
bottom of the rudder.
2) Using a ruler and a pen place a mark onto
the bottom of the rudder. The back edge of
the clasp should line up with this mark.You
may find it necessary to bend the tail wheel
wire down slightly so it lines up with the
clasp without binding.
2) Using a pen, mark the locations of the
two mounting screws. Remove the tail wheel
bracket and drill 1mm pilot holes at the loca-
tions marked.
3) Secure the tail wheel bracket in place us-
ing two 3x10mm wood screws. Be careful
not to overtighten the screws.
3) While holding the clasp firmly in place,
use a pen and outline the clasp onto the rud-
der.
4) Remove the clasp, and using a modeling
knife, remove the covering from inside the
lines you drew. Use 220 grit sandpaper and
carefully roughen the inside surface of the
nylon clasp.
5) Slide the clasp back into position and
carefully glue it into place using Kwik Bond
Thin C/A. Hold the clasp in place until the
glue completely cures. Secure by 1 machine
screw.
1) Assemble and mounting the wheel pants
as shown in the following pictures.
2) Follow diagram below for wheel pant in-
stallation :
WHEEL AND WHEEL PANTS
INSTALLATION.
Control clasp.
Machine Screw
2x12mm
3x12mm
