Diono Radian R120, Instruction Manuals

Page: 45 / 64

F
o
r
w
ar
d-
Faci
ng
I
n
s
tal
la
ti
on
45
Route the Top Tether strap to the
appropriate anchor and connect.
Do not tighten until car seat is
installed ( See pages 49 for Top
Tether installation instructions).
Slide the seat belt through the
forward-facing belt path behind
the fabric and buckle it. Be sure
belt is not twisted. Put seat belt
in locking mode, if necessary.
Pull shoulder portion of seat belt
to remove slack so the lap portion
is tightening down on the car seat.
It is best to do this close to
the buckle.
To check for a tight fi t, grab the
seat near the label that states
“forward- facing belt path” with
one hand and give it a moderate
tug. It should move less than1 inch
side-to-side, back-to-front.
Remove slack from Top Tether strap
if an appropriate anchor is
available ( See page 49 for Top
Tether installation).
Forward-facing Lap-Shoulder Belt
Installation (cont.)
❒
See final checklist on page 52
3.
4.
5.
6.
2.