Dionex UltiMate 3000 Series, Operating Instructions Manual

Page: 57 / 236

UltiMate 3000 Series:
SD, RS, and BM Pumps
Operating Instructions Page 43
3.6 Connecting a Dionex ESA Detector to the Pump
Note the following if you want to connect an ESA Corona or Coulochem detector to the
pump:

To connect the detector to a digital I/O port on the rear panel of the pump, use the 6-pin
mini-DIN signal cable (part no. 6000.1004).

For information about how to connect the detector to the pump, follow the instructions in
the Chromeleon Help. The Help provides separate sections for connecting these detectors
to an UltiMate 3000 system pump, including details about the appropriate cabling and
settings required in the Server Configuration program.

Only ESA Corona
When the pump and detector are connected and configured as described in the
Chromeleon Help, pumping is stopped and an error message appears on the pump display
and in the Chromeleon Audit Trail ('An emergency stop was requested over the digital
input line') if an error occurs in the detector. Check the detector and take appropriate
remedial action (

Detector manual ).

Only ESA Coulochem III
When the pump and detector are connected and configured as described in the
Chromeleon Help, the detector cell is automatically turned off when the pump flow is
zero. Also observe the information on page 90.
For more information, see the Chromeleon Help.