Dinolift 240RXT, Operating Instructions Manual

Page: 46 / 113

DINO 240RXT
46
6. Inspection of the boom and the chassis
-
extend the telescope and inspect the platform, its attachment, the articulated arms and the boom
-
inspect the boom joints and play of the sliding pads, readjust if necessary. Lubricate the sliding
surfaces
-
check the condition, locking and adjustment of the Flyer-chains
-
secure the attachment to the boom of the unloaded flyer-chain by pulling the chain by hand with the
boom fully extended
-
inspect the turning device and its attachment and lubricate the bearing (4 nipples)
NOTE!
Excess grease pressure may press out the turning bearing seal.
-
check the turning bearing play
Max. allowed axial play is about 1 mm.
-
check the attachment bolts for the turning device for tightness: 280 Nm (M16)
150 Nm (M12)
If you have to turn open or tighten the attachment bolts, do not forget to use bonding adhesive (tighten
crosswise)
-
check the chassis and the welded seams on it; especially around the turning device and attachment
points of the outriggers
inspect the outriggers.
-
lubricate the bearings of the boom and outrigger joints